絲印機電氣及氣動作基本工作原理?
絲印機電氣及氣動作基本工作原理—
絲印機電氣及氣動作基本工作原理部分:
此機針對不易變形承印之物之平面絲印需要而設計的,其印刷行程、印刷頭、滑行架、控制驅動等關鍵機構,均采用進口元件,整機性能穩定可靠,可獨立調較速度。
此機備有真空吸氣及自動離網等裝置,特別適合印刷薄膠片、銘牌、線路板和卡紙等物料。
1、 電源:通常國內的電源電壓是三相電,每相的電壓是380V,電源還有一條叫零線。我廠的機臺都要接上零線。這三相電任向一條對零線的電壓都是220V,用戶處的這條零線必須和三相電一起走(即在同一個漏電開關一起走),不能隨便拉一條零線。
2、 氣源:一般空氣壓縮機出來的氣壓為5kg/cm2—8 kg/cm2(也有用MP表示),施加于氣缸的氣壓越大,出力越大,這樣設備使用就不穩定,所以設備都自帶了穩壓器,穩定在5 kg/cm2。調機時必須檢查用戶的氣源在5 kg/cm2以上,不夠的在空氣壓縮機自動開關調整為5-8 kg/cm2。
3、 電器元器件:
A、 接觸器:通電到線圈吸合后......